Hello,

I hope this message finds you well.

I would like to inquire about the possibility of manufacturing a specific custom shape. Attached, you will find a dimensioned 3D model for your reference. Could you confirm whether a similar design can be produced?

The shape in question is a wedge/roof-like form. From a top-down view, all sides are rectangular except the rear, which is angled. The base is derived from a rectangular block with a height of 3.5 cm, featuring the following inclines:
Forward tilt: 1.5 cm
Leftward tilt: 1.5 cm
Rightward tilt: 1 cm

The material would need to be high-density memory foam, with a nylon upper surface and an anti-slip bottom material. If necessary, I am open to simplifying the design to facilitate production.

Thank you for your time and consideration. I look forward to your response.

Best,
Filip Benda, Hello,

I hope this message finds you well.

I would like to inquire about the possibility of manufacturing a specific custom shape. Attached, you will find a dimensioned 3D model for your reference. Could you confirm whether a similar design can be produced?

The shape in question is a wedge/roof-like form. From a top-down view, all sides are rectangular except the rear, which is angled. The base is derived from a rectangular block with a height of 3.5 cm, featuring the following inclines:
Forward tilt: 1.5 cm
Leftward tilt: 1.5 cm
Rightward tilt: 1 cm

The material would need to be high-density memory foam, with a nylon upper surface and an anti-slip bottom material. If necessary, I am open to simplifying the design to facilitate production.

Thank you for your time and consideration. I look forward to your response.

Best