Good morning. Here are the plans for the faucets I need for my project. I know that for some faucets a mold is mandatory. My requests and explanations are as follows:

1 - give me a quote for 250 units of each part and detailed mold for each faucet.
2- for the square tap, is it possible to use the same mold for the mixer version and the cold water version?
3- my plans are based on existing faucet plans. If you wish, you can advise me on a different shape or detail that will make my brand's faucet different from what my competitors can buy.
4- For the plan of the square faucet, understand that the faucet with its rosette and its fixing supports will be a single block and the rear fixing plate another part manufactured separately.
There are therefore two parts 1: The tap block 2: The rear fixing plate.
5 - For the already existing simple round cold water tap if it is possible to do the assembly with already existing parts it suits me. Be careful to understand the plan for fixing the tap through the wooden board.

I remain at your disposal for any questions. THANKS. Sincerely