Hello, below are detailed instructions for preparing the product, as well as pictures.
Hello, here are the requirements for the belts that I am asking you to make for me. I need 200 units about 5.52 meters wide with 18 strings on the edges on each side, plus 200 units about 6.75 meters wide with 22 strings on the edges on each side, plus 200 units of a belt 7.97 meters wide with 26 strings on the edges on each side. Here are a few points about the belts: 1. In all dimensions, the cubes in the vertical rows should be the same size. In the example that I am sending you, only 15 strings on the edges fit, so do not make me this width of the pattern. 3. As in the example, I want the knitting method at the end to be the same. 4. The length of the belts is 3.50 meters, that is, the belt itself without the strings. 5. The belt itself should be tightly fastened and with a hard texture like the example. 6. The strings on the edges should be very tight and not loose. 7. Each string will consist of three threads. Thin but hard like in the example I will send 8. The belt should be as dark and black as possible 9. I would recommend that the small threads of the fringe be closed each thread to itself with a special glue or a hot knife, preferably so that it does not unravel 10. The length of the strings is 15 centimeters plus 5 centimeters in the section that splits 11. The strings are placed on both sides 12. The strings are installed on the belt and it is not attached but added.